Description

2 in 1 Jamma Switcher Stereo Audio - external power supply connector Standalone Mode - 2 in 1 Jamma Switcher - Board inputs - any combinations listed below. Two mono arcade boards Two stereo arcade boards One mono and one stereo arcade board Stereo add on mode - This board can also be used to add one stereo audio Jamma input onto your pre-existing 2 in 1 or 6 in 1 Jamma switcher. The audio switcher board acts as a pass through on Ch.1 when connected to another Jamma switcher. The Ch.2 input will be your stereo audio Jamma connection. Connect your Jamma switcher to the Ch.1 input on the new audio switcher. Make sure the audio jumpers are configured for mono on Ch.1 Connect your board with stereo audio to Ch.2 input. Configure the audio jumper on Ch2. for stereo. If you're pre-existing Jamma switcher is using Player 1 Start and Player 2 Start to switch between games, you will need to change the input selection on the new Stereo-Audio switcher. Y ou can use a combination of the start buttons 1 and 2 or Player one button-1 or button-2. Example : You're pre-existing Jamma switcher is set on Player 1 start and player 2 start to select. The new Stereo-Audio switcher can be set to switch with Player 1 and Button 2 or Player 2 and Button 1 or Button 1 and Button 2 . Options: 1. Aux power in or out. This jack is connected in parallel to the main power lines. 2. Mono or Stereo selection for each game input. When the Jamma Switcher switches between mono and stereo, no need to worry about your speakers impedance. Connect your Left speaker to pin 10 & L. Right speaker to 11 & M on the Jamma out. You can have one stereo game and one mono game connected or any combination. Just select what you want for each channel. In Mono both speakers play what’s on pin 10 & L from Ch.1 or Ch.2. 3. Ground lift for pin 27 and e on Ch.1 or Ch.2 Jamma inputs. 4. Two options to switch between games. First, a single button can be installed on your cabinet to the game select input. Second, you can use a combination of the start buttons 1 and 2 or Player one button-1 or button-2. Example: If you have Player 1 start and player 2 start selected. Push and hold player 1 start and press player 2 at the same time on and off to cycle between games. 5. Channel one or channel two can be configured to stay powered on all the time or switched on/off. 6. Diode protection for coin meters. Pin 10 (parts side) Left speaker + Pin L (solder side) Left speaker – Pin 11 (parts side) Right speaker + Pin M (solder side) Right speaker -